The NKS-V017-A processing board is a high performance industrial Carrier card dedicated to high performance data acquisition and communications based on the Xilinx Virtex-7 XC7VX690T FPGA family. The NKS-V017-A board enables designers to prototype high-performance digital transceivers. The board includes a DSP Processor (TMS320C6678) which incorporating the new and innovative C66x DSP core, this device can run at a core speed of up to 1.25 GHz. The sample clock can be supplied from PLL clock distributor, externally through a coax connection or supplied by an internal clock source. The on-board FPGA Mezzanine Connectors (FMC-HPC) can make a high bandwidth data transfer channel with VITA 57.1 standard modules.

Clock's:

• Flexible Synchronous PLL Clock Tree with Internal or External Clock
• On board 200MHz Oscillator

Processor's:

• Virtex-7 XC7VX690T-2FFG1761I Xilinx Device
• Digital Signal Processing (DSP)
• TMS320C6678 TI Device
• ARM Microcontroller AT91SAM7X256 Atmel Device
• SP3XC3S200AN-4FGG256I for Power Sequence and DSP Separate Configuration
• SP3XC3S700AN-4FGG484I for GPIO & RS485

Memory's:

• 6 Gb DDR3 Component Memory (6x [128 Mb x 16] 32b&64b Devices) for Virtex-7 FPGA
• 8 Gb DDR3 Component Memory for DSP
• 1 Mb I2C EEPROM for DSP local boot (remote boot possible)
• 128 Mb NOR Flash for DSPSPI local boot

Interface's:

• Ethernet PHY 10/100/1000 Interface with RJ-45 Connector for FPGA and DSP
• 2x FMC-HPC Conn. With VITA 57.1 Standard
• GPIO, EMIF, SRIO and PCIe Interface between FPGA and DSP
• On-Board XDS100 type Emulation using High-speed USB 2.0 interface for DSP
• RS232/RS485 UART for DSP
• 24x RS485, 24x GPIO and 1x CAN BUS Serial Interfaces

Other's:

• Multi-boot Configuration
• Status and Debug LEDs
• Power on/off Slide Switch
• Physical Dimensions (L: 259.96mm, W: 244.44mm)
• Operating temperature: -40°C to +85°C (Industrial)
• 8V ~ 15V External Voltage Supply
• Maximum Power Consumption in Full Load: 160W
• Operation System Support: Windows & Linux